Good at Vibrating object measurement , restore object actual status
F4010-K are based on the principle of laser diffraction (Fresnel diffraction), with a simple structure that can provide stable and
accurate measurements for a long service time.
4 -axis devices with less bind area, more comprehensive sampling data to reflect wire actual status. It is very suitable to strict ovality requirement application.
Applicable to various materials such as electric wire & cable,steel wire, enamelled copper wire, medical tubing, 3D filament, and more, regardless of their transparency.
4-axis measurement ,Less bind area
The below figure explains the relation between the measurement result and nos of axis. The more nos of axis, the less bind area it is , and measurement accurate will be more accurate.
Single axis sampling frequency of 10 KHz
Sampling frequency can reach to 10KHz due to no motor running speed limitation,which enables to get more information of the object under
measurement.
Touch Screen,Computer,Cellphone
F4010-K can be managed by computer ,cellphone and Touch screen,like parameter setting ,measurement data management ,and so on.
Technical Specification
| Model | F4010-K |
| Axis | 4-axis |
| Measurement data | diameter and ovality, lump and necks |
| Frequency | 40KHz(1-Axis:10K) |
| Measurement range | 0.3~10mm |
| Repeatability(1) | ±0.2μm |
| Accuracy(2) | diameter accuracy:±(0.001+0.01%*D)mm ovality accuracy: ＜0.5mm:±0.004mm ≥0.5mm: ±2(0.001+0.01%*D)mm |
| Min defect height | 0.01mm |
| Min defect length(3) | 0.2mm(wire speed120m/min)
0.8mm(wire speed500m/min) |
| Size | 275*242*60mm |
| Working power source | 24V ±10% 40VA |
| Running temperature | 5℃~50℃ |
| Display | LED display |
| Commuincation port | Standard:WIFI,RS485 MODBUS RTU,CAN
Option:PROFIBUS,PROFINET, EtherNet/IP,EtherCAT |
| Electrical port | Standard: digital output(relay),digital input,analog input,encoder pulse input port
Option:PI feedback control (4) |
| Data colletion & analysis | available (option DS14 ZT display and control system,DMS1000) |
| Out-of-tolerance alarm | available |
| Transparent mode | available |
Note:
(1) set sliding window as 100ms, outside diameter repeatability of φ1mm round rod at measurement center area
(2) set sliding window as 100ms, outside diameter deviation of φ1mm round rod at measurement area
(3) set defect measurement average time as 0ms, the minimum defect length which cannot be missed at the measurable area
(4) PI feedback control is option, but must order at placing order
